Here is a Millivolt Source i built for Calibration in the early days. It uses only CMOS Digital and Mixed Chips from Intersil and CD40xx Series.
In this Circuit, digital potentiometer, connect pushbutton switches to fast and slow with one end to +7.5V, when you hold the button down the analog voltage will ramp up-down, fast or slow, this will enable you to make a digitally controlled millivolt source or power supply.
Later i tried a unit with 8748 part of the code in my uC section. This is with Ramp-up and Ramp-down using only two buttons. This works even now, The support below is an HRC Fuse Holder made of Phenolic or Epoxy Resin. The mV Terminations are on Top.
This was supposed to have Analog in and Analog out. Some parts of the circuit may be in the 80C51 page. This has ramp-up and ramp-down settings for the Increment and Decrement buttons. This helps setting setpoint quickly. There is also debouncing for the pushbutton.